Standard Board Thickness And Layer Stack
When electronic devices were transitioning to transistors and integrated circuits, pcb boards were built using breadboarding on plywood workbenches, where the top layer of a plywood sheet was replaced with a material called Bakelite. If you are familiar with plywood, then you know that the thickness of a single ply in plywood is 1/16 in., or 1.57 mm.
This thickness became something of a standard when board-to-board connections became necessary. Early board-to-board connections used rack units with edge connectors, and these edge connectors needed to match this standard thickness. Nowadays, instead of Bakelite, we use materials that allow etching and plating, such as epoxy laminates like FR4.
If you take a moment to think, you’ll realize there is no reason for this thickness to be preferable over any other thickness other than to accommodate the layer count and copper weight that is used in a particular board. Many pcb manufacturers opt for this board thickness with lower layer counts because that’s the way it’s always been, or in order to accommodate a standardized edge connector. Looking throughout the pcb industry, many routing standards (e.g., PCIe add-in cards) specify this value for board thickness to this day.
As pcb boards have become more complex, and as copper weight and layer counts have increased for different applications, pcb boards tended to become thicker. Two popular board thicknesses are 2.36 mm and 3.18 mm, which just happen to be 150% and 200% of the 1.57 mm board thickness.
DFM and Board Thickness
If you start looking at pcb manufacturer websites, most pcb manufacturers offer fabrication to a variety of thickness values. Although the 1.57 mm value is something of a required capability for any manufacturer, many pcb manufacturers have adapted their capabilities to fabricate boards with various multiples of this thickness.
Different pcb manufacturers can fabricate boards with different layer counts and copper weights, and many will offer their set of “standardized” pcb board thicknesses. Manufacturers will also limit the allowable board size to specific values for different stackups. Other manufacturers will simply limit the panel size to specific dimensions. You should always check your manufacturer’s capabilities before designing your layer stack in order to keep costs in check and ensure manufacturability.
Choosing the right pcb layer thickness, and thus the total board thickness, depends on a number of factors. When working with impedance controlled boards, the thickness needs to be carefully controlled and will depend on the desired trace width. The weight of your pcb board, component compatibility requirements, and required connectors are also significant factors. You’ll need to balance all of these alongside satisfying your manufacturer’s capabilities in order to ensure your board is fully manufacturable.
Whether you are designing a two-layer board or a complex PCB with more than 12 layers, you need a PCB manufacturer to turn your product from a document into a product. PCBQuick is a Chinese brand with 12 years of PCB manufacturing experience. We can provide PCB related help from design to manufacturing and assembly. We would be glad to get in touch with you!